Dremel Tool Bracket for Lathe

[ad_1]

Dremel Bracket by scrdmgl — I made a Dremel Tool bracket using two 1 1/2″metal pipe hangers from Lowes that fit the OD of the Dremel perfectly. In the center of the “ring” or hanger, there is a boss for a 3/8″ 16 NC screw. I choosed a piece of CRS 3/4″ thick by 1 1/4″ wide to fit my lathe tool post. To drill the holes for the screws in the lathe’s center line, I attached the block in one the four tool locations and by using a MT5 dead center in my lathe spindle I scribed a line in the bar…

[ad_2]